Before you revile yourself, sit back and relax that you could supplant your Nintendo DS case all alone. Be that as it may, be cautioned, it is a precarious activity. You need unique instruments and LOTS of persistence. In the event that you do not think you have the stuff, it is in every case better to send it in the closest trusty store for fix. Should you have the guts to do this current, how about we begin? At the point when you are quiet and prepared to disguise your Nintendo DS case, place a fabric or towel for base and keep a saucer helpful to place in the screws. At that point, expel the battery case screw on the down right corner, two different screws on the left side, and the screw on the DS card space. Take the battery off. expel the screw and the spread inside as well.
After all screws are made sure about on your saucer, expel this posterior cautiously. Expel all parts from the shell, however be cautious in case you are evacuating the shoulder fastens as they have springs that may leap out. Take out the highly contrasting links close to the DS card opening, and take the dark one underneath the space to the opposite side. At that point expel the screws on either side. You would now be able to expel the PCB from the other portion of the base piece of your necessary switch accessories case. Expel the two screws on top A-B-X-Y fastens, and flip the dark bar over the heading cushion upside to snap off the level wire and tenderly take it off downwards. Presently turn your DS around with the goal that the rear is confronting you straight up. In the first place, evacuate the two elastic cushions on top.
Evacuate the force marker. Put the level wire on the thin space, push it left shrewd while pushing the shell right savvy to the level wire simultaneously. Presently expel the base part from the top piece of your Nintendo DS case, and set it aside. Direct your concentration toward the top piece of the case. Sneak out the point agent on the left side, roll the level wire and remove the ring on the opposite side. Next, take a gander at the top screen. There are four screws covered up underneath cushions on each corner around the top screen, evacuate both the covering and the screws. It is somewhat testing, so take as much time as is needed. At the point when you are set, push this top part with your thumbs on each side of the screen and your forefingers underneath, and slide it upwards. You ought to have the option to open the top shell. Roll the level wire and push right astute to take it off totally.